12/24 battery charger,Colloidal battery, lithium battery universal.

Size: 150*82*64mm

Product model: Jx-12/2401A-10/5

Output cable length: 65cm

Net weight: 490g

Input voltage: AC110-220V(50-60Hz)

Input cable length: 80cm

Output current: DC -5A-10A $ 0.5A(Max)

Output voltage: DC13.8V-29.4V ≥ 0.2

Scope of application: 12V 4Ah-150Ah Lead-acid battery (LiFePo4 batteries 14.6V)

24V 5Ah-60Ah Lead-acid battery (LiFePo4 batteries 29.2 V)

Some of the above parameters are manually measured with slight errors.

Please refer to the actual product.

Connection instructions

1. Detect whether the battery parameters match the charger;

2. Red clip connects the battery positive (+) and black clip connects the battery negative (-);

3. After the positive and negative poles are connected, the screen will be lit up. At this time, the ambient temperature, voltage and remaining capacity will be detected in a cycle (refer to the figure below) Note: After the battery has just been used, it needs to be left for 1 hour, and the following figure detects the remaining capacity of the battery.

4. After connecting the household power supply, the screen will automatically switch to the charging state (start-stop/hook charging mode without devulcanization stage) after entering the devulcanization stage for about 5 minutes. During the charging process, the screen will display the voltage, current and ambient working temperature of the battery and the current charging progress.

5. If the positive and negative connection is wrong or abnormal, the screen

" flashes, displays Err, and

there is a beeping tone.

6. Select the charging mode that matches the battery (see mode selection for details)

7. After charging, the battery power bar on the screen is full (100%) and displays "FUL"

It is recommended to

continue to float for about 1 to 2 hours. Wait for the screen to display "OFF" to turn off.

8. After unplugging the AC plug first, remove the positive and negative clips and complete the charging.

Winter and summer recharge

1. Wintert 28°C Normal temperature: 6°-27°C (The icon is not displayed.)

2.During the charging, the microcomputer detects the environment and working temperature automatically without manual setting. It automatically adjusts to the appropriate charging state according to the detection of environment temperature, extending the service lite of the battery and safe charging. The working temperature is based on the very 5s when start to plug it in electric supply.

3. The ambient temperature of 3-5/S is identified once, and there is a certain error range when detecting, but it does not affect the normal charging of the charger.

Repair function

1. Connect the battery and plug it into the power supply, trigger the "mode" key five times to enter the repair

2. It is recommended to repair the car battery for about 4 hours, and the motorcycle battery and water battery are recommended to repair for about 2 hours. (If the battery does not heat up, the repair time can be extended).

3. The repair mode also has current. The battery can also be fully charged after a long-term repair. After the repair is completed, the battery bar on the screen is full (100%) and displays will automatically enter the floating charging stage, and 1 hour later the screen will show that the "OFF" shutdown is completed.

4. If you need to stop the repair or charging process in advance, just remove the charger and disconnect the power first.